Sharp MX-LCX3N Service Manual page 13

4) Remove the screws, and remove the solenoid.
D. Torque limiter
1) Remove the paper feed unit. (Refer to "2. Each unit removal")
2) Remove the screw, and remove the paper guide block.
3) Remove the screws, and remove the rear cover.
4) Disconnect the connector.
5)
E. Transport roller
1)
2)
3)
4)
F. Handling solenoid
1)
2)
3)
MX-LCX3N DISASSEMBLY AND ASSEMBLY 6 – 4
Remove the E-ring, and remove the torque limiter.
1
2
3
Remove the paper feed unit. (Refer to "2. Each unit removal")
Loosen the screws, and remove the paper guide block.
Remove the rear cover, and disconnect the connector. (Refer
to "D. Torque limiter")
Remove the screw and the E-ring, and remove the parts.
Remove the transport roller.
Check that there is no paper, and lower the paper feed table to
the lower limit with the main unit simulation mode.
Pull out the tray.
Remove the screws.
4