Verifying The Hardware Configuration - Cisco 815 Quick Start Manual

Integrated services router cabling and installation

Hide thumbs Also See for Cisco 815:

Table of Contents

Because Cisco SDM is installed on your router by default, we recommend using Cisco SDM to perform the

Note

initial configuration.

See the "Configure the Router Using Cisco Router and Security Device Manager" section on page 20 to learn how to

configure your router using Cisco SDM, or how to obtain Cisco SDM and install it on your router.

If you do not have Cisco SDM on your router, and would like to use Cisco SDM, go to the following location

Note

for instructions on how to install it on your Cisco 815 series router:

http://www.cisco.com/go/sdm

If you see the following messages, the router has booted and is ready for initial configuration using the setup command

facility or the command-line interface (CLI):

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

To use the setup command facility and use the CLI to configure the router, see the

Configuration Using the Setup Command Facility"

Command Facility"

If the rommon 1> prompt appears, your system has booted in ROM monitor mode.

Verifying the Hardware Configuration

To display and verify the hardware features, enter the show version command. This command displays the system hardware

version; the installed software version; the names and sources of configuration files; the boot images; and the amount of installed

DRAM, NVRAM, and flash memory.

sections.

and

"Setting Up the Initial Configuration Using the Setup

"Setting Up the Initial

Table of Contents