Verifying The Initial Configuration - Cisco 815 Quick Start Manual

Integrated services router cabling and installation

Hide thumbs Also See for Cisco 815:

Table of Contents

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface Ethernet1/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface Ethernet1/1

shutdown

no ip address

end

Step 11 Respond to the following prompts. Choose [2] to save the initial configuration:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started!

The user prompt appears:

Router>

Verifying the Initial Configuration

To verify that the new interfaces are operating correctly, enter the following commands:

• show interfaces—Verifies that the interfaces are operating correctly and that the interfaces and line protocol are in the

correct state—up or down.

• show ip interface brief—Displays a summary status of the interfaces configured for IP.

• show configuration—Verifies that you configured the correct hostname and password.

After you complete and verify the initial configuration, your Cisco 815 integrated services router is ready to be configured for

specific functions. See the

configuration procedures.

"Where to Go Next" section on page 23

for information about locating documentation for advanced

Table of Contents