Threading The Machine - Janome DKS100 SE Instruction Book

z
v
x
c
b
n
m
z
q
w
x
c
r
v
b
n
m
i
e
t
y
u
16

Threading the Machine

Raise the presser foot. Press the needle up/down button
to raise the thread take-up lever to its highest position.
CAUTION:
Turn off the power switch or press the lockout key
before threading the machine.
z Turn the power switch off. Draw the thread around the
upper thread guide.
q Upper thread guide
x While holding the thread near the spool, draw the
thread down along the right channel.
w Right channel
c Pull the thread up around the bottom of the thread
guide plate.
Pull the thread up along the left channel.
e Thread guide plate
r Left channel
v Firmly draw the thread up and to the back of the take-
up lever. Draw the thread forward to pass it into the
take-up lever eye.
t Take-up lever eye
b Pull the thread down along the left channel and pass
the thread through the lower thread guide.
y Lower thread guide
n Slide the thread behind the needle bar thread guide
on the left.
u Needle bar thread guide
m Thread the needle from front to back, or use the
needle threader.
i Needle