Adjustments During The Embroidery Process; If The Bobbin Runs Out Of Thread - Baby Lock SOLARIS VISION BLSA3 Instruction And Reference Manual

ADJUSTMENTS DURING THE EMBROIDERY PROCESS

ADJUSTMENTS DURING THE EMBROIDERY PROCESS
Note
• Be careful not to bump the embroidery unit
carriage or the embroidery foot when
removing or attaching the embroidery frame.
Otherwise, the pattern will not embroider
correctly.

If the Bobbin Runs out of Thread

When the bobbin begins to run out of thread
during embroidering, the machine will stop and
the message below will appear.
a
Leave the message displayed and then press
the "Reinforcement Stitch" button
sew reinforcement stitches to prevent
stitches from unraveling.
b
Touch
Memo
• If the message appears when only a few more
stitches are necessary to complete
embroidering, simply press the "Start/Stop"
button, allowing about 10 more stitches to be
embroidered.
• If [Upper and Bobbin Thread Sensor] in the
General settings screen is set to [OFF], the
message shown above does not appear.
• Touch
52
.
to close the message.
c
Touch
 After the thread is automatically cut, the carriage
will move.
d
Leave the message displayed and then
continue with the next step.
e
Unlock the frame-securing lever and
remove the embroidery frame.
* Be careful not to apply strong force to the fabric at
this time. Otherwise, the fabric may loosen in the
frame.
to
f
Insert a wound bobbin into the machine.
(Refer to "Setting the Bobbin" on page 19.)
g
Attach the embroidery frame.
h
Touch
 The carriage will move to its previous position.
i
Press the "Reinforcement Stitch" button to
sew reinforcement stitches at the beginning
of sewing, and then press the "Start/Stop"
button to continue embroidering.
.
.