Baby Lock SOLARIS VISION BLSA3 Instruction And Reference Manual page 108

Hide thumbs Also See for SOLARIS VISION BLSA3:
Table of Contents

Advertisement

EMBROIDERY APPLICATIONS
Note
• Depending on the pattern density and fabric
used, there may be shrinking of the pattern or
the appliqué may be misaligned with the
placement line. We recommend cutting
slightly outside of the cutting line.
• When using patterns that are vertically and
horizontally symmetrical, use a chalk pencil to
indicate the pattern orientation before cutting
it out.
• Carefully cut out the pattern on the outline you
just sewed. Do not cut inside the cutting line,
otherwise the appliqué fabric will not be
caught by the appliqué stitch.
i
Use two layers of adhesive water soluble
stabilizer material with their sticky sides
together, and then hoop them in the
embroidery frame.
Note
• If water soluble stabilizer is used, it is not
necessary to remove the stabilizer material
after sewing the appliqué outline. To reduce
shrinkage of the pattern, we recommend
using water soluble stabilizer.
• Put together two layers of water soluble
stabilizer, otherwise the stabilizer material
may tear during embroidering.
j
Thread the machine with the thread for the
outline from step
placement line for the appliqué position
(APPLIQUE POSITION).
a Pattern placement line
106
l
, and then sew the
a
k
Lightly apply glue or spray adhesive, and
paste the appliqué piece so that it aligns
with the placement line.
Note
• Before pasting the appliqué piece down,
make sure the appliqué piece is positioned
correctly within the placement line.
l
With the machine threaded using the thread
for the outline from step
outline (APPLIQUE).
a Outline of appliqué piece
Memo
• The outline is sewn using satin stitching.
• Some glue may get onto the embroidery foot,
needle, and needle plate at this time. Finish
embroidering the appliqué pattern, and then
clean off the glue.
m
After embroidering is finished, remove the
stabilizer material from the embroidery
frame.
n
Use scissors to cut the excess water soluble
stabilizer from outside the appliqué outline.
o
Soak the appliqué piece in water to dissolve
the water soluble stabilizer.
j
, embroider the

Advertisement

Table of Contents
loading

Table of Contents