Verifying The Leds - Cisco 805 Series Quick Start Manual

Router cabling and setup
Hide thumbs Also See for 805 Series:
Table of Contents

Advertisement

9

Verifying the LEDs

Verify the power, Ethernet, and serial connections by checking the LEDs. Figure 5 shows the components that you must verify
and the location of their corresponding LEDs.
Figure 5
Components and Associated LEDs
CD LED
LINK
Ethernet
LED
port
The following table describes the normal pattern for these LEDs and what to do if you get an abnormal pattern. For more
information on all LEDs, see Chapter 1, "Product Overview" of the Cisco 805 Router Hardware Installation Guide.
Normal
LED
Pattern
Explanation
OK
On
Power is supplied to the
router.
LINK
On
Ethernet device is
connected.
CD
On
Packets are sent or received
from serial port.
(Carrier
detect)
1. For information on how the setting of this button on a hub affects the setting of the router HUB/NO HUB button,
see Chapter 2, "Installing the Cisco 805 Router" in the Cisco 805 Router Hardware Installation Guide.
2. The CD LED will not light until you configure the serial interface. For more information on configuring the serial
interface, see the Cisco 805 Router Software Configuration Guide.
8
OK LED
Serial
Power connector
port
and switch
If Abnormal Pattern
If off, see Chapter 3, "Troubleshooting" in the
Cisco 805 Router Hardware Installation Guide.
If off, toggle HUB/NO HUB button (if set to HUB
[in], reset to NO HUB [out] or vice versa).
off, see Chapter 3, "Troubleshooting" in the
Cisco 805 Router Hardware Installation Guide.
If off for a long time, see Chapter 3,
2
"Troubleshooting" in the Cisco 805 Router
Hardware Installation Guide.
Front panel
Back panel
1
If still

Advertisement

Table of Contents
loading

Table of Contents