Trigger Test - Alesis DM Pro Service Manual

DM PRO (D6) Trigger Test Procedure (2)
Software: V2.00 Trigger V2.00
DD: 12/28/99
REV: D
I) UPLOAD D6 USER & TRIGGER PROGRAM :
A) Press the "CURSOR" button while powering up the D6 unit.
B) Press the "STORE" button.
- Press "CURSER" button until you see " Load USER from Factory? (STR)"
- Press "STORE" again to LOAD USER PROGRAM.
- Press"CURSER" button until you see " Load TRIGS from Factory? (STR)"
- Press "STORE" again to LOAD TRIGGER PROGRAM.
C) Press "MIDI" button and adjust the VALUE ENCODER until display reads
"AuxPed Ctl#: 016".
Press CURSER
"AuxPed Ctl#: KIT+".
D) Press "KIT" button.
Adjust "VALUE" ENCODER until "KIT" button starts to flash.
Adjust "VALUE" ENCODER until display reads "00 "ProRockKit".
Press "KIT" Button to load drumkit.
E) Plug FOOT SWITCH into the AUX PEDAL plug. Press KIT button. Press the
FOOT SWITCH, and the display should load the next kit.
*FAIL UNIT IF DIFFERENT*
E) TURN POWER OFF.........
II. TRIGGER TEST:
Equipment:
1. 1 pcs of ¼" Mono audio CABLE & Special make Y CABLE.
2. 1 pcs of headphone.
3. 1 D6 Unit.
4. 1 Trigger fixture (YAMAHA DRUM PAD)
1 Trigger pad w/clamp
5. 1 Drum stick
6. 1 foot switch
NOTED: PLEASE MAKE SURE D6 UNIT HAS BEEN UPLOAD WITH USER
PROGRAM BEFORE THIS TIRGGER TEST PROCEDURE.
1-time and adjust the VALUE ENCODER until display reads
1