Bosch Climate 5000 Series User Manual page 9

3.3.3 Dry Mode (For Dehumidifi cation)
Ensure the unit is plugged in and power is available. The OPERATION indicator on
the display panel of the indoor unit will be fl ashing.
1. Press the MODE button to select DRY mode.
2. Press the UP/DOWN buttons to set the desired temperature. The
temperature can be set within a range of 60°F ~ 86°F in 1°F increments.
3. Press the Power/OK button to start the air conditioner.
3
Figure 6
In the DRY mode, you can not switch the fan speed. The fan
speed will be automatically controlled.
While in Dry Mode, the unit will not shut down when it reaches the set
temperature. The unit will will continue to run until it reaches 50 °F.
Bosch Climate 5000 Series Remote Control (06.2022)
3.3.4 Timer operation
Press the TIMER ON/OFF button to set the amount of time before the unit
automatically turns on/off . Press the TIMER OFF button to set the auto-off time of
the unit.
To set the Auto-on time.
1. Press the TIMER button. The remote controller shows TIMER ON, and the
last Auto-on setting time will be shown on the LCD display area. Now it is
ready to reset the Auto-on time . This feature will turn the unit on after the
specifi ed time.
2. Use the TEMP. UP and DOWN buttons to select the desired Auto-on time.
Each time you press the button, the time changes by half an hour between 0
and 10 hours and by one hour between 10 and 24 hours.
3. After setting the TIMER ON ,there will be a one second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the time will disappear and the set
temperature will re-appear on the LCD display window.
To set the Auto-off time.
4. Press the TIMER button. The remote controller shows TIMER OFF, and the
last Auto-off setting time will be shown on the LCD display area. Now it is
1
ready to reset the Auto-off time. This feature will turn the unit off after the
specifi ed time.
5. Use the TEMP. UP and DOWN buttons to select the desired Auto-off time.
Each time you press the button, the time changes by half an hour between 0
2
and 10 hours and by one hour between 10 and 24 hours.
6. After setting the TIMER OFF ,there will be a one second delay before the
remote controller transmits the signal to the air conditioner. Then, after
approximately another 2 seconds, the time will disappear and the set
temperature will re-appear on the LCD display window.
Figure 7
1
User Manual
2
| 9