Installation - Haier XQG50-QF800 Operation Manual

Installation

As shown in figure1 remove all the packing materials
(including the foam base).
Check attachments and materials.
Name
Operational Quality Water
Qu'ty
manual certificate hose
Model
XQG50-
1 1 1
QF800TX(SS)
Remove the packing screws as shown in figure 2.
The packing bolts protect the appliance from shock during trans-
portation The steps betow should be followed before using the
appliance,
1. Remove the rear panel of the washing machine;
2. remove the three packing bolts from the rear panel of the wash-
ing machine,the rubber hose and then the shock absorption chan-
nel steel;
3. reinstall the back plate;
4. fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept in a
safe place for later use)
Adjusting the position of the washing machine .There are ad-
justable feet under the bottom of the washing machine. Before use,
the washing machine should be adjusted, as shown in figure 3, so
that it is level.
4
Fig 1
Drainage Plastic Distributor
holder plugs box
1 3 1
Fig 2
Fig 3
Trouble shooting
The following circumstances do not constitute problems. De net contact
the maintenance service until the problem has been confirmed.
Problem
Poor connection to power supply
The washing machine fails to
Power failure
operate
Door is not properly closed
Machine has not been switched on
Water is not turned on
Water pressure is less than 0.05MPa
Washing machine does not fill
The inlet hose is kinked
with water
Water supply failure
The program knob is not properly set
The door is net properly closed
The water supply and Check that the height of the water hose is below
drainage do not stop 80cm
Drainage hose is blocked
Drainage failure
Drainage hose end is below 100cm above the
floor level
Some packing fixing bolts removed
Strong vibration during spin
Washing machine on a uneven surface
O p e r a t i o n s t o p s b e f o r e
Water or electricity failure
completion of the wash cycle
The detergent is not a Iow foam type
Excessive foam in the drum
Excessive detergent has been used
Possible Cause
13