Trouble Shooting Answer To Question - Haier XQB50-18 User Manual

Trouble-shooting Answer to question
(If there's breakdown, please pull off the power plug before checking) The following phenomena are not breakdowns
sometimes. Please confirm again before sending it to repair. If there are real breakdowns, please come to the special
maintenance department or after-sale service department of our company. Do not repair it by yourself.
Phenomenan
The digitron displays E0.
The drainage cannot work, or is too slow.
The digitron displays E1.
It stops running in midway. The digitron
displays E2.
The safety switch acts, and the
spinning cannot work. The
digitron displays E3.
The water filling does not work, or is
slow. The digital displays E4.
The digitron displays E6.
The digitron displays E8.
The digitron displays E9.
Not wash
The machine does
not act
Not spin
There's abnormal sound
inside the machine
The water tap leaks
Common phenomena
Phenomena
The spinning is intermittent when it starts.
The wash procedure is pausing.
Select SPIN program, but it doesn't work.
The pulsator pauses during water inlet in
wash and rinse.
There may be some water flowing out of the
drain hose in the first use of the machine.
The reason
The top lid is opened during reserve
procedure.
Is the drain hose put down?
Is the drain hose blocked?
The top lid is not closed.
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is there water
supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
The power voltage is too low.
The power voltage is too high.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Are the laundries set flat?
Is the machine slanting?
Are the laundries put slantingly in spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
How to settle
Close the top lid.
Put down the drain hose. Open and close the
top lid once.
Clean the foreign material. Open and close
The top Lid Once.
Close the top lid.
Reorder the laundries. Close the top lid.
The machine will start running after 10
seconds of being placed horizontally.
Open the water tap. Push the start/Pause
button once.
Clean the water inlet valve then push
the start/Pausebutton once.
Push the sStart/Pause button once.
Please contact the after-sales
service department.
Pull off the power plug. Wait for the
voltage resuming normal before usage.
Please use it when there's power supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Set the laundries flat.
Adjust the machine to be even
Reorder the laundries and close the top lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
Explanation
Balance the laundries to avoid slanting.
The cloth sensor is checking the cloth. It will
add water after about 48 seconds.
The program is setting the drain time. Some
time is needed before it starts spinning.
It is to avoid splashing during water inlet.
It is the water remained in the factory
inspection of performance.