Table of Contents
Advertisement
Removing and installing components
NOTE:
The images in this document may differ from your computer depending on the configuration you ordered.
Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe
Screw list
NOTE:
When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE:
Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE:
Screw color may vary with the configuration ordered.
Table 1. Screw list
Component
Solid-state drive
Hard-drive and optical-drive
supporting bracket
SD-card reader
WLAN card
Processor-fan and heat-sink
assembly
Power-supply unit
System board
Screw type
M2x3
#6-32
M3x5
M2x3
Captive
#6-32
#6-32
Quantity
1
2
1
1
4
3
7
Removing and installing components
Screw image
2
9
Advertisement
Table of Contents
