Table of Contents
Advertisement
Steps
1. Ensure that the securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Press down on the memory module until the memory module snaps into position and the securing clip locks in place.
CAUTION:
To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE:
Repeat step 1 to step 3 when installing more than one memory module in your computer.
Next steps
1. Install the
disk-drive
cage.
2. Install the
3.5-inch
hard-drive.
3. Install the
2.5-inch
hard-drive.
4. Install the
side
cover.
5. Follow the procedure in
Processor fan and heat-sink assembly
Removing the processor fan and heat-sink assembly
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
disk-drive
About this task
The following images indicate the location of the processor fan and heat-sink assembly and provide a visual representation of
the removal procedure.
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
after working inside your
before working inside your
cage.
computer.
computer.
Removing and installing components
53
Advertisement
Table of Contents
