Table of Contents
Advertisement
The vent cap and vent tubing have sharp edges. Wear
gloves when unpacking and installing.
connect the vent pipe and install the Fireplace insert
For fireplace vent pipe and insert installation refer to
information 1 through 6 below. see Figure 10.
1.
Measure chimney height.
2.
Stretch liners out completely.
3.
Trim liners to chimney height to allow 2 to 3 feet extra.
4.
Attach liners to cap and flashing with clamps and sealant.
5.
Verify chimney is clear of blockage and damper is open.
6.
Install the vent tubing down the chimney.
7.
Install leveling legs. see Figure 11.
38102-4-0319
installation
caUtion
Figure 10
Seal off the area between the termination cap and the top
of the solid-fuel chimney opening into which the vent cap
is installed to avoid downdrafts and/or cold air problems.
Figure 11
caUtion
Page 17
Advertisement
Table of Contents
