Millivolt Operating Instructions (30 Series) - Empire Comfort Systems MILLIVOLT DVCD42FP30 Homeowner's Manual

MILLIVOLT OPERATING INSTRUCTIONS (30 SERIES)

MILLIVOLT SYSTEM
The standing pilot burns continuously even when the main
burner is oFF.
1. Follow the SAFeTY and LIGHTING INSTRUCTIoNS for
standing pilot controls found in this manual and on labels
found in the control area.
2. During the operating season, leave the control valve knob in
the "oN" position. This will allow the pilot flame to remain lit.
Turn the burner flame on or off with the fireplace RemoTe/
oFF/oN switch, wall switch or remote controls.
NOTE: The gas control valve allows you to increase or decrease
the height of the main burner flame. The control valve has a
pressure regulator with a knob as shown in Figure 2. Rotate the
knob counterclockwise to "HI" to increase the flame height and
clockwise to "Lo" to decrease the flame height.
3. When the heating season ends, turn the RemoTe/oFF/oN
switch to "oFF" and the control valve to "oFF". The system,
including the pilot light, will be shut down.
NOTE: If batteries fail in the remote, and immediate heat is
desired, turn the RemoTe/oFF/oN switch from the RemoTe
position to the oN position.
Page 4
Figure 2
39669-0-0618