Map Your Device In Pen Mode - Wacom CTL-672 User Manual

Map your device in pen mode

Pen
In mode, you use the pen like a regular pen, and you interact with the device as if it is your paper. Each point on
the device maps absolutely to a specific point on your monitor, and the cursor jumps to the corresponding point on
your monitor when you place your pen on the device.
Pen
If you select mode, you can see a representation of how your device maps to your monitors on the
tab. If you want a different mapping than what is shown, you can change it.
1. In Wacom Tablet Properties, select your pen from the
2. From Mode, select Pen
By default, the active area of the device maps to your entire monitor. If you are using more than one
monitor, the device maps to all monitors.
CAUTION
: If you change the display properties in your computer's display menu, you are also
changing the mapping on this tab.
Screen Area
3. From , select which part of your monitor that you want the device to map to:
Full
Select if you want to map to the entire area of the monitors connected to your computer.
Select Portion
following ways:
Drag Handles
Under
to map to.
Click to Define
Select
Enter Coordinates
Monitor
Select a
4. From Tablet Area , select which part of your device that you want mapped to the
The options are similar to the
Force Proportions
5. Select
as on your monitors.
If you select Force Proportions
but a portion of the device active area may no longer be usable.
If you do not select
the screen.
Tip
: To help you decide which setting to select, watch the red borders of the image on this tab while
selecting and unselecting
.
if you want to define a section of your monitor to map to. Select the section in any of the
, drag the corners of the red border to define the screen area that you want
and use your cursor to select the screen area that you want to map to.
in pixels.
if you want to map to the entire area of a single monitor.
Screen Area
if you want the vertical and horizontal proportions to be the same on your device
and draw a circle on the device, it displays as a circle on the screen,
Force Proportions
and draw a circle on the device, it might display as an ellipse on
Force Proportions
Tool
list and then select the
options.
to see how it affects mapping.
User's Manual
Mapping
Mapping
tab.
Screen Area you selected.
44
44