Table of Contents
Advertisement
Advanced Mapping settings
In Advanced Mapping settings, you can change between Pen mode and Mouse mode. You can also turn on
advanced options
, which allows you to access advanced mapping features such as selecting a portion of a multi-
display set up or mapping a portion of your device to your display(s).
Topics on this page
Show advanced options
Map your device in Pen mode
Map your device in Mouse mode
Show advanced options(s)
Show advanced options
The
portion
and
Use custom area
Note:
Show advanced options
Turning
device users.
Map your device in Pen mode
Pen mode is the default mode and the recommended setting for your device. In Pen mode, you use the pen like a
regular pen, and you interact with the device as if it is your paper. Each point on the device maps absolutely to a
specific point on your monitor, and the cursor jumps to the corresponding point on your monitor when you place your
pen on the device.
Note:
"Pen mode" is required for
1.
Open Wacom
Center.
2. Select your device in the
3. Select
Mapping
and then click
Mode
4. Under
, select "Pen".
Map your device in Mouse mode
Mouse
In
mode, you use the pen like a mouse. The cursor stays on the point that you left it when you pick up your
pen, and you interact with your device like you interact with a mousepad or trackpad.
Important:
Mouse mode is an advanced feature. Wacom recommends using your device in
Pen
mode, which is the default setting.
1.
Open Wacom
Center.
2. Select your device in the
Mapping
3. Select
and then click
4. In the
Mode
section, select "Mouse".
slider is turned "Off" by default. Turning it "On" enables advanced features --
-- in
Mapping
settings.
"On" is recommended for experienced Wacom
mapping your device to your
Devices
sidebar.
Advanced
.
Devices
sidebar.
Advanced
.
display(s).
User's Manual
75
Show
Select
75
Advertisement
Table of Contents
