Ordering Information - Emerson PACSystems RX3i Important Product Information

GFK-2884K
Introduction
The PACSystems RX3i Carrier IC695CEP001 interfaces a remote node, consisting of one RX3i I/O module, to a PROFINET
I/O Local Area Network (LAN).
The optional RX3i Expansion Carrier IC694CEE001 attaches to the RX3i CEP001 Carrier and provides the ability to add
one additional RX3i IC694 I/O module to the remote node.
The RX3i CEP001 Carrier functions as a PROFINET IO-Device. The RX3i CEP001 Carrier's main Remote I/O functions
include:
• Scanning all the modules within the remote node (input and output scan)
• Publishing data on the PROFINET network to a PROFINET IO-Controller at a user-specified production period
• Receiving data from a PROFINET IO-Controller on the PROFINET network at a customer-specified production period
• Managing PROFINET communication and module configuration between a PROFINET IO-Controller and modules
within the remote node
• Managing the state of the I/O when communications is lost
• Publishing fault information (alarms, diagnostics, and such) to the PROFINET IO-Controller
• Provides power to the CEE001 Expansion Carrier
The insertion and removal of I/O modules is the same as in an RX3i Universal Backplane. Refer to GFK-2314, PACSystems
RX3i System Manual.
The RX3i CEP001 Carrier provides two RJ-45 Ethernet receptacles. It supports 10/100BASE-TX Ethernet standard
interface.
Features
• Full programming and configuration services for all supported RX3i I/O Modules using PAC Machine Edition. Refer
to the section, Supported I/O modules
• Support daisy-chain/line, star, or ring (redundant media) network topologies
• Two switched Ethernet ports: two eight-conductor RJ-45 shielded-twisted pair 10/100 Mbps copper interfaces
• USB port for field updates of firmware using Win Loader
• Supports Hot-standby CPU Redundancy using PROFINET I/O: requires RX3i CEP001 2.01 GSDML version 2.3 or later
• Supports HART® Pass Through using PROFINET
Note: The USB port is for firmware upgrades only. It is not intended for permanent connection.
The CEP001 Carrier requires a user-supplied +24 Vdc power source.

Ordering Information

CAT Number
IC695CEP001
IC694CEE001
Description
RX3i CEP001 Carrier with RJ-45 Copper Ethernet Interface
RX3i CEE001 Expansion Carrier
Feb 2022
2