Chapter 3; Using Command Line Console Feature; Connection; Connecting With Management Port - NEC N8405-019 User Manual

Chapter 3

Using Command Line Console Feature

This section explains the command line console feature.

Connection

To use the command line console feature, a management console (e.g., personal computer) must be
connected to the management port.

Connecting with Management Port

The EM card has two interfaces; the serial port and the network port (100BASE-TX/10BASE-T) as
a management port.
IMPORTANT:

To connect with the management network, use "EM1 port" and
"EM2 port" at the rear of the Blade Enclosure.

The network ports on the EM card do not support the jumbo frame
feature. Do not enable the jumbo frame feature on the network to be
connected with the EM card.
NOTE:
setup or maintenance of EM card.
Connect with the management port when providing initial
- 25 -