Advertisement
10. Place Air Conditioner in window opening. It
should sit on Bracket assembly so that Curtain Frame
and cabinet Side Guide are against top and side
window jambs. Mate front of Bracket with Base
Guide attached to the bottom of base pan.
11. Drill 1/8 inch holes in window track through
the existing holes on Base Guide. Screw 4 Type B
screws through the holes. (Fig. 8)
12. If this is a casement window installation, proceed
to Casement Window Installation. If not, slide inner
window sash firmly against side of the cabinet.
13. Drill 1/8" inch hole in window jamb to align
with the existing holes in the Curtain Frame. Attach
Curtain Frame to window frame with 2 Type B screws.
(Fig. 8)
NOTE: Check all seals and plug any remaining air
gaps with a suitable weatherproof caulk.
14. If this is a casement window installation, Proceed
to Casement Window Installation. If not, stuff the
Foam Seal Strip between the vertical sash and the
window glass. (Fig. 9)
15. Attach the L Bracket with a Type B screw. (Fig.
9)
Casement Window Installation
1. Installation procedure is the same as that described in steps 1 through 11 and ste
the Horizontal Sliding Window installation.
2. If the window opening is wider than 15-3/4 inches you will need to install a fille
Make this panel from 3/4 inch thick wood and run it the full length of the window. At
securely to the window frame and paint it to protect it from the weather.
3. Since styles and sizes of casement windows vary widely, it is advisable to have th
conditioner installed by someone skilled in this type of installation.
Before using the air conditioner secure
the front grille with 1 screw(Type A).
1. Open the inlet grille and remove
the air filter.
2. Fasten the front grille with screws.
3. Reinstall the air filter.
4. Close the inlet grille.
14
NOTE!
Base pan
Base Guide
Bracket
Type B screw
Window Track
Window locking
bracket
Type B screw
Fig. 8
Foam seal strip
Fig. 9
Advertisement
