Advertisement
Installing Unit into A Window
Window Requirements
1. These instructions are for a horizontal sliding or a casement window.
2. The electrical outlet must be within reach of the power cord.
For installation in a casement window, the window frame assembly and the side of the building must
be adequate to support the weight of the air conditioner.
21" min.
40 1/2" max.
15 1/2"
min.
Horizontal sliding window
Horizontal Sliding Window Installation
1. Loosely attach the Support Bracket
to the bottom of Bracket using Bolts,
and Nuts. Attach the Leveling Bolt and
Nut. (Fig. 1)
2. Remove protective backing from Window
Track Seal and apply seal to window track.
(Fig. 2)
3. Measure and lightly mark a line 8-1-14 inches
from window jamb. Center the Support Bracket
assembly on the window track and fasten with 4
Type B screws. (Fig. 2)
4. Put the Support Bracket against the outside wall
and tighten the Bolts on top of the Bracket. Adjust
the Leveling Bolt so that the air conditioner will be
installed with a very slight tilt(about 1/4") downward
toward the outside for proper drainage. Tighten the
nut. (Fig. 3)
NOTE: DO NOT drill a hole in the bottom of the
base pan. The air conditioner is designed to operate
with the bottom of the base pan approximately half-
full of water.
12
21 1/2" min.
15 1/2" min.
16 1/2" max.
Casement window
B o l t
Nut
Spport Bracket
Window Jamp
8 1/4 inches
Window Track
Seal
Window Track
About 1/4"
Bracket
Leveling Bolt & Nut
Fig. 1
Type B screw
Fig. 2
Fig. 3
Advertisement
