Table of Contents
Advertisement
3 Get started
Always follow the instructions in this chapter in
sequence.
Install remote control battery
Caution
Risk of explosion! Keep batteries away from heat,
‡
VXQVKLQH RU ÀUH 1HYHU GLVFDUG EDWWHULHV LQ ÀUH
Danger of explosion if battery is incorrectly replaced.
‡
Replace only with the same or equivalent type.
‡
The battery contains chemical substances, so it should
be disposed of properly.
‡
Keep children away from the battery.
)RU ÀUVWWLPH XVH
Remove the protective tab to activate the
battery.
To replace the battery, refer to the
illustration. C
Connect power
Caution
Risk of product damage! Ensure that the power voltage
‡
corresponds to the voltage printed on the back or
underside of the clock radio.
Risk of electric shock! When you unplug the AC adapter,
‡
DOZD\V SXOO WKH SOXJ IURP WKH VRFNHW 1HYHU SXOO WKH
cord.
Warning
‡
To reduce the risk of fire or electric shock, do not
expose this clock radio to rain or moisture.
Connect the power adapter to the wall
socket. D
Set clock
1
In standby mode, press and hold SET TIME
for two seconds to activate clock setting
mode.
» The hour and minute digits begin to
blink.
10
EN
All manuals and user guides at all-guides.com
2
Press
/
and
the hour and minute.
3
Press SET TIME WR FRQÀUP
» [12H] or [24H] begins to blink.
4
Repeat Steps 2-3 to select 12/24 hour
format.
» The set time is displayed.
Note
When iPod/iPhone is connected, the clock radio
‡
synchronizes time from the iPod/iPhone automatically.
Turn on
Press .
» The clock radio switches to the last
selected source.
Tip
‡
To select a source, press SOURCE repeatedly or the
source selection buttons on the remote control.
Switch to standby mode
Press
again to switch the clock radio to
standby mode.
» 7KH FORFN LI VHW DSSHDUV RQ WKH
display panel.
/
repeatedly to set
Advertisement
Table of Contents
