Dell EMC VEP4600 Operating System Installation Manual page 26

Waiting while BMC reboots..
\ updating BIOS image
******************************
* BIOS version = 3.41.0.9-12 *
******************************
updating primary image only..
BIOS image is ./VEP4600-BIOS-3.41.0.9-15.BIN
01
INFO: Yafu INI Configuration File not found... Default options will not be applied...
Creating IPMI session via network with address xxx.xx.xxx.xxx...Done
-------------------------------------------------
YAFUFlash - Firmware Upgrade Utility (Version 4.112.0)
-------------------------------------------------
(C)Copyright 2016, American Megatrends Inc.
Beginning BIOS Update...
Uploading Image : 100%... done
Flashing Firmware Image : 100%... done
Verifying Firmware Image : 100%... done
Done with updating image
Reseting CPU
Chassis Power Control: Cycle
\ Error: Unable to establish IPMI v2 / RMCP+ session
updating CPLD image
Already have 0x10 programmed
updating MC1_CARD CPLD image
Already have 0x2 programmed
Power cycle chassis for updates to take effect
Package version: x.x
Packaged images:
BMC image:
BIOS image: x.xx.x.x-xx
CPLD image: XxXX
Wifi CPLD image: XxX
Note:If BMC version is less than 1.23 CPLD versions will not be shown correctly
1. Automatically update all firmware components
2. BMC image[Primary version:x.x, backup version:1.23]
3. BIOS image[Booted version: x.xx.x.x-xx]
4. CPLD image[CPLD version: XxXX]
5. rNDC left CPLD image[CPLD version: XxX]
6. rNDC right CPLD image[CPLD version: XxX]
q. Exit
5. After firmware upgrade complete, enter q to exit.
6. Once all firmware updates are complete, a system power cycle is required either with remote power cycler or manually unplugging and
plugging back the power cord.
NOTE: The power down state should be a minimum of fifteen seconds for the complete power drain.
NOTE: This solution has a limitation that rNDC Firmware upgrade cannot be done through the BMC network. Follow
the next section for the workaround.
26 Upgrade Firmware through BMC
x.x