Cisco DVD-ROM Upgrade Manual page 5

Disconnect the power cable, a small connector with four connected wires, from the floppy disk drive in
Step 3
the housing, as shown in
Figure 2
Step 4 Follow the internal pale yellow SCSI cable, as shown in
its connection to the tape drive, located at the top right and partially covered by the backplane.
Step 5 Disconnect the SCSI cable from the tape drive.
Do not to pull off the cable from the hard drives.
Caution
Follow the power cable that you disconnected in
Step 6
receptacle, which is labeled on the backplane power source, as shown in
Figure 3
Disconnect the connector at PWR1.
Step 7
78-16489-01
How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
Figure 2.
Floppy Disk Drive Inside the Housing
PWR1 Receptacle
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
Power Cable
SCSI Cable
Figure 2, from the floppy disk drive to identify
Step 3 to the power source connector at the PWR1
Figure 3.
5