Table of Contents
Advertisement
Quick Links
Cisco MeetingPlace Audio Server Release 5.2
DVD-ROM Upgrade Procedure
Cisco MeetingPlace Audio Server Release 5.2 supports a new DVD-ROM drive that replaces the Travan
NS20 tape drive.
Note
You must upgrade the Cisco MeetingPlace 8112 before upgrading Cisco MeetingPlace Audio Server
Release 5.0.2 or Release 5.1.0 to Release 5.2.
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure provides instructions for
removing the Travan NS20 tape drive and installing the DVD-ROM drive. For regulatory and compliance
information for Cisco MeetingPlace Audio Servers, see
for Cisco MeetingPlace
Contents
•
•
•
•
•
•
•
•
•
•
•
Audience
This upgrade procedure is for Network Consulting Engineers (NCE) or fully trained Cisco partners.
78-16489-01
Products.
Audience, page 1
Scope, page 2
Required Hardware and Software, page 2
Required Tools and Equipment, page 3
Additional References, page 15
Obtaining Documentation, page 16
Documentation Feedback, page 17
Obtaining Technical Assistance, page 18
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
Regulatory Compliance and Safety Information
1
Advertisement
Table of Contents
Related Manuals for Cisco DVD-ROM
Summary of Contents for Cisco DVD-ROM
-
Page 1: Table Of Contents
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure Cisco MeetingPlace Audio Server Release 5.2 supports a new DVD-ROM drive that replaces the Travan NS20 tape drive. Note You must upgrade the Cisco MeetingPlace 8112 before upgrading Cisco MeetingPlace Audio Server Release 5.0.2 or Release 5.1.0 to Release 5.2. -
Page 2: Scope
7” VGA monitor – – Slim keyboard In addition to the software in the Cisco MeetingPlace 8112 DVD-ROM Kit, the following software is required: When you upgrade from Cisco MeetingPlace Audio Server Release 5.0.2 or Release 5.1.0 to Note Release 5.2, you must upgrade the hardware before you upgrade the software. -
Page 3: Required Tools And Equipment
Required Tools and Equipment To upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM, you need the following tools and equipment: Computer with terminal emulation software installed • DB9-female-to-DB9-female null-modem cable • Phillips #2 screwdriver • • ESD protection •... - Page 4 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM To save the license keys, enter savelicense. Step 4 You can use these license keys if you need to reinstall the original CPU. Remove the disk from the floppy disk drive.
- Page 5 Figure 3 PWR1 Receptacle Disconnect the connector at PWR1. Step 7 78-16489-01 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Figure Power Cable SCSI Cable Figure Step 3 to the power source connector at the PWR1 Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure...
- Page 6 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Remove the power cable from the top disk drive on the top left from back of server, as shown in Step 8 There are two cables connected: the pale yellow SCSI cable and the power cable. Do not remove the Note SCSI cable from the disk drive.
- Page 7 Figure 6 IDE Cable From the front of the server, hold the DVD-ROM drive with the ejector button on the top and place the Step 2 IDE cable, connector end first, into the drive bay.
- Page 8 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM If you have to pull out the power cable to connect it to the DVD-ROM drive, make sure that you put the Step 5 power cable back into the drive bay. Slide the power cable back in as far as possible so that you can access the cable from the back of the server.
- Page 9 Step 8 The BIOS Setup Utility appears, as shown in Figure 8 BIOS Setup Utility Main Screen 78-16489-01 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Figure Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure...
- Page 10 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM By using the right arrow key, choose Advanced, as shown in Step 9 Figure 9 Advanced Screen By using the down arrow key, choose Embedded Flash, as shown in Step 10 In the Task Section of the Embedded Flash screen, press Enter.
- Page 11 When the server begins booting up, press F2 on the monitor (LILLIPUT) to enter setup mode. Step 4 78-16489-01 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Figure 11. This revision appears for approximately 8 seconds and “Troubleshooting BIOS Upgrade Failure”...
- Page 12 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM If the server does not boot up (you cannot get into the Setup mode on the monitor), contact Cisco TAC as described in the “Replacing the CPU and Updating the License Keys” section on page In Setup mode, press the right arrow to choose the Advanced menu.
- Page 13 We recommend that you log your session. Insert the Update Diskette for M3 DVD-ROM into the floppy disk drive. Step 3 To install the DVD-ROM software on the system hard drive, enter update at the tech$ prompt and choose Step 4 d for diskette.
- Page 14 How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM 4) Local File q) (Quit Update) Enter choice: 1 Please insert the update CD in the drive, then wait for the drive to be quiet before continuing. Press <ENTER> to continue or <CONTROL-C> to abort.
-
Page 15: Additional References
Cisco MeetingPlace Audio Server 5.2 System Manager's Guide for Cisco MeetingPlace 8100 series • http://www.cisco.com/univercd/cc/td/doc/product/conf/mtgplace/audio/52/5206smg2.pdf Cisco MeetingPlace Audio Server 5.2 Installation Planning Guide for Cisco MeetingPlace 8100 • series http://www.cisco.com/univercd/cc/td/doc/product/conf/mtgplace/audio/52/5206ipg3.pdf 78-16489-01 Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure Additional References... -
Page 16: Obtaining Documentation
Nonregistered Cisco.com users can order documentation through a local account representative by • calling Cisco Systems Corporate Headquarters (California, USA) at 408 526-7208 or, elsewhere in North America, by calling 1 800 553-NETS (6387). Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure... -
Page 17: Documentation Feedback
Never use a revoked or an expired encryption key. The correct public key to use in your correspondence with PSIRT is the one that has the most recent creation date in this public key server list: http://pgp.mit.edu:11371/pks/lookup?search=psirt%40cisco.com&op=index&exact=on 78-16489-01 security-alert@cisco.com psirt@cisco.com Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure Documentation Feedback... -
Page 18: Obtaining Technical Assistance
(S1 or S2 service requests are those in which your production network is down or severely degraded.) Cisco TAC engineers are assigned immediately to S1 and S2 service requests to help keep your business operations running smoothly. Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure 78-16489-01... -
Page 19: Obtaining Additional Publications And Information
For current Cisco Press titles and other information, go to Cisco Press at this URL: http://www.ciscopress.com Packet magazine is the Cisco Systems technical user magazine for maximizing Internet and • networking investments. Each quarter, Packet delivers coverage of the latest industry trends,... - Page 20 Obtaining Additional Publications and Information iQ Magazine is the quarterly publication from Cisco Systems designed to help growing companies • learn how they can use technology to increase revenue, streamline their business, and expand services. The publication identifies the challenges facing these companies and the technologies to help solve them, using real-world case studies and business strategies to help readers make sound technology investment decisions.