Cisco DVD-ROM Upgrade Manual page 4

How to Upgrade to the Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM
To save the license keys, enter savelicense.
Step 4
You can use these license keys if you need to reinstall the original CPU.
Remove the disk from the floppy disk drive.
Step 5
Powering Down the Cisco MeetingPlace 8112
To power down the Cisco MeetingPlace 8112, perform the following steps:
At the tech$ prompt, enter halt disable.
Step 1
To power down the system, enter y and press Enter.
Step 2
Wait for the
Step 3
Turn the power switch to the off position.
Step 4
Step 5 Unplug the main power cable from the server.
Removing the Tape Drive from the Cisco MeetingPlace 8112
To remove the tape drive from the Cisco MeetingPlace 8112, perform the following steps:
Step 1 From the back of the Cisco MeetingPlace 8112, loosen the screws on the floppy disk housing, located
on the upper left side.
Slowly slide out the floppy disk housing and secure the housing to the back of the
Step 2
Cisco MeetingPlace 8112 with a releasable tie wrap, as shown in
Figure 1
Do not allow the housing to hang by the attached cables.
Caution
Cisco MeetingPlace Audio Server Release 5.2 DVD-ROM Upgrade Procedure
4
"**** LynxOS is down ****"
Secured Floppy Disk Housing
message to appear.
Figure 1.
78-16489-01