Enrolling A Fingerprint - HP iPAQ hx2000 Additional Information

Enrolling a Fingerprint

HP ProtectTools suggests fingers for you to use during the swiping activity.
You can select a different finger at any time. To select a different finger,
tap the finger you want to swipe in the Hand icon. The new finger is
highlighted in light blue.
You should enroll at least two fingers (index fingers are suggested; pinky
fingers are not recommended). Enrolling fingerprints from your dominant
hand tends to be easier. It can take between two and eight finger swipes
to enroll a fingerprint, depending on the fingerprint quality.
The Fingerprint screen uses color coding to display the status of your
fingerprint swipe.
If the color around the oval is... Then...
Blue
Green
Red
To enroll a fingerprint:
On the Fingerprint screen, use the diagram to tap the finger that
1.
you are going to enroll.
2. Swipe the selected finger, as instructed.
NOTE: Maintain a firm, consistent pressure against the sensor when
swiping a finger. One way to do this is to press your thumb against the
bottom of the HP iPAQ while swiping your index finger. You should
begin the swipe at the first joint of your finger and continue downward
with a smooth slow motion, taking one to two seconds to complete the
swipe.
If you need additional assistance at any time, tap the Training button.
No fingerprint has been taken for the
finger.
The fingerprint swipe was good quality.
The fingerprint swipe was poor quality.
Continued
81