5H-18
AIR BRAKE VALVES
25. 0 -n n g s (55 arid 56) inexhaust'cover (54).
26. Exhaust cover (54) in valve main body (51).
27. Retaining ring (53) in valve main body (51).
28. Relay piston spring (65) in valve main body (51)
large diameter end first.
• The relay piston spring (65) is not used in all
valves.
29. O-ring (62) and sealing ring (86) on valve cover
(52).
V
• Use lubricant to hold them in place.
BENDIX ST-3
Remove or Disconnect (Figure 23)
4 * * f
1. Body (4) from, cage (2)/
2. Ball valve (3).
i 3. Release pin (1).
/ 4. Spring (6).
S 5 3
Clean
All parts in mineral spirits or another suitable Sol
vent.
Install or Connect (Figure 23)
1. Spring (6) in cage (2).
2. Release pin (1).
3. Ball valve (3).
,
"
N O T IC E : S e e
N o tic e " o n p a g e 5H -1 .
4. Body..(4).
;
Tighten
Body (4) to 16 N.m (12 ft. lbs ).
SPRING BRAKE CONTROL VALVE
BENDIX SR-1
4- +
Remove or Disconnect (Figure 24)
1. Hex socket plug (8)..
2. Spring (9).
3. Guide (10):
4. Check valve (11).
5. Screws (20).
6. Exhaust cover (19),
7. Inlet and exhaust valve assembly (32).
8. Retainer ring (18).
SAFETY VALVE
>
?
,
'
, .
! ! l I
30. O-ring ;(64) on relay piston (63):
31. Relay;piston (63) in valve main body (51).
32. Mounting bracket on valve cover (52).
• Align the marks made during disassembly.
33. Valve cover (52) and mounting bracket on valve
main body (51).
34. Four cap screws (60) and washers (61).
Q
' Tighten
Cap screws (60) to 17 N.m (13 ft. lbs.).
■ r ,
:;1 : Release Pin
2. Cage
}3. Ball Valve
4. Body
5. Exahust Port
6. Spring
Figure 23—Bendix ST-3 Safety Valve
9. Seal retainer (17), inner O-ring (15), and outer
O-ring (16) from retainer,
10. Valve spring (14).
11. Valve retainer (13).
12. Cap (22) and O-ring (23).
13. Stop (24).
14. Spring (25).
15. Valve; disc (26).
ff ~ | important
• Tlie cover in the next step is Under spring load
and should be held firmly while removing the
B6042
' ;
,