Grounding Instructions; Drawer Installation - Monogram ZWL1126SRSS Installation Instructions Manual

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of
an electrical short circuit, grounding reduces the risk
of electric shock by providing an escape wire for
the electric current. This appliance is equipped with
a cord having a grounding wire with a grounding
plug. The plug must be plugged into an outlet that is
properly installed and grounded. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
WARNING
Improper use of the grounding plug can result in a risk
of electric shock.
Do not use an extension cord. If the power supply
cord is too short, have a qualified electrician or
serviceman install an outlet near the appliance.
Correct Installation
3-prong plug
Grounding pin
3-prong receptacle
Grounded receptacle box
31-7000165 Rev.0
Installation Instructions
Permanent and

DRAWER INSTALLATION

Figure 5
1. Place the drawer adjacent to the wall or cabinet
opening. Plug the power supply cord into the
electrical outlet.
2. Loop (do not tie) a 36" (91 cm) string around the
power supply cord before the drawer is slid into
place. This will keep the cord from falling behind the
drawer.
3. Lift drawer into cabinet cutout using the opening as
a grip. Carefully guide the drawer into the prepared
opening.
4. As you slide the drawer back, pull the string so that
the cord will lie on top of the drawer in a natural loop
and avoid pinching the cord between the drawer and
the wall.
5. When you are sure the cord is out of the way, slide
the drawer ¾ way back into the opening. Remove the
string by pulling on one end of the loop.
6. Slide the drawer all the way until the mounting flange
is flush with the face of the cabinet. See Figure 5.
7. Open the drawer. Using the 4 holes on the mounting
flanges as a template, drill pilot holes the cabinet
using a 1/16" drill bit. See Figure 5.
8. Secure the drawer with the 4 screws supplied. It is
recommended that the screws be hand tightened.
Parts Supplied
Mounting
Flange
4 Screws
5