Anti-Tip Block; Electric Outlet - Monogram ZWL1126SRSS Installation Instructions Manual

ANTI-TIP BLOCK

NORMAL INSTALLATION STEPS
Anti -Tip BLOCK Installation Instructions
To reduce the risk of tipping of the drawer, the
Anti-Tip block must be properly installed located 14
13/16-inches above the floor on which the Drawer
Microwave will sit. The anti-tip block must be provided
and pre-installed by the purchaser of the product or
builder before install can be done. The anti-tip block
is not provided by installer. See Figures 1 and 2. The
Anti-Tip block prevents serious injury that might result
from spilled hot liquids.
If the Drawer Microwave is ever moved to a different
location, the Anti-Tip block must also be moved and
installed. When installed to the wall, make sure that
the screws completely penetrate the dry wall and are
secured in wood or metal so that the block is totally
stable. When fastening, be sure that the screws do
not penetrate electrical wiring or plumbing.
4
Installation Instructions
6"
Anti-Tip
block
3 1/2"
Figure 3

ELECTRIC OUTLET

The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It
is recommended that a separate circuit serving only
this appliance be provided.
The drawer is equipped with a 3-prong grounding
plug. It must be plugged into a wall receptacle that
is properly installed and grounded. Should you only
have a 2-prong outlet, have a qualified electrician
install a correct wall receptacle.
Note: If you have any questions about the grounding
or electrical instructions, consult a qualified electrician
or service person.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Always check electrical
codes for requirements.
Preferred electrical
outlet location*
Figure 4
5"
4"
31-7000165 Rev. 0