2. Insert and route the cable through the routing channel.
3. Replace the M2.5x5.0 screws to secure the hard drive cable connector to the computer.
4. Install the:
a.
hard drive
b.
base cover
c.
battery
d.
battery cover
5. Follow the procedure in
Keyboard lattice and Keyboard
Removing the keyboard
1. Follow the procedures in
2. Remove the:
a.
battery cover
b.
battery
c.
hard drive
3. To remove keyboard cable:
a. Peel the tape to access the keyboard cable [1].
b. Disconnect the keyboard cables from the touchpad board [2]
4. To remove the keyboard:
a. Using plastic scribe pry the keyboard trim from the bottom and work along the top edge and remove it from the
computer [1, 2, 3].
b. Remove the M2.0x2.5 screws that secure the keyboard to the computer [4].
c. Lift and slide the keyboard to remove it away from the computer [5].
14
Disassembly and reassembly
After working inside your
Before working inside your
computer.
computer.