Check for a dial tone
Press
on the handset or
the base. If you hear a dial tone, the
installation is successful.
If you do not hear a dial tone
• Make sure the installation procedures
are properly done.
• The handset may take a second or
two to find the telephone base and
produce a dial tone. This is normal.
Wait an extra second before dialing.
• If the previous suggestions do not
work, disconnect the telephone
line cord from your telephone and
connect the telephone line cord to
another telephone.
• If there is no dial tone on that other
telephone either, your telephone
line cord may be defective. Install a
new telephone line cord.
• If changing the telephone line cord
does not help, the wall jack (or
the wiring to this wall jack) may be
defective. Try using a different wall
jack in your home to connect your
IS8251, IS8251-2, IS8251-3, IS8251-4,
and IS8251-5 telephone, or contact
your telephone service provider
(charges may apply).
Before use
After you install your telephone or
power returns following a power outage
on
and battery depletion, the handset will
prompt you to set the date and time, and
to configure the Smart call
answering system through voice guide.
Set date and time
NOTE
• Make sure you set the date and
time including the year correctly;
otherwise the answering system does
not announce the correct day of the
week for your recorded messages
time stamp.
Handset
1. Use the dialing keys (0-9) to enter the
date (MM/DD/YY), and then press
to confirm.
2. Use the dialing keys (0-9) to enter the
time (HH:MM), and then press
to confirm.
Base
1. Use the dialing keys (0-9) to enter the
month (MM), date (DD) and year (YY).
Then, press Next.
2. Use the dialing keys (0-9) to enter the
hour (HH) and minute (MM). Then,
press
p/q
3. Press
Save
*Includes licenced QaltelTM technology.
QaltelTM is a trademark of Truecall Group Limited.
20
blocker*
to choose AM or PM.
to save.
and