Table of Contents
Advertisement
Setup
NOTE: Install the base unit away from electronic equipment, such as personal
computers, television sets or microwave ovens. Avoid excessive heat, cold, dust
or moisture.
LOW BATTERY indication: If the battery power
becomes low, a low-battery icon will be shown
at the lower left corner of handset display. The
handset will beep until you place the handset in
the charger. When in standby mode, the low-
battery display is shown:
Battery Care and Maintenance
•
The maximum standby time on a fully charged battery is six days. Average
talk time on a fully charged battery is five hours.
•
The battery needs charging when:
— A new battery is installed in the handset.
— The phone beeps twice every five seconds.
— The screen displays BATTERY LOW and the low battery icon.
•
Place the handset in its base so the CHARGING light turns on. The battery
is typically fully charged in 12 hours.
•
You can keep the battery fully charged by returning the handset to its base
after each use.
•
If you repeatedly get a low battery indicator, even after charging overnight, the
battery should be replaced. Use only VTech batteries.
CAUTION! To reduce the risk of fire or injury to persons or damage to
! ! ! ! !
the telephone, read and follow these instructions carefully:
Charge the battery provided with or identified for use with this
product only in accordance with the instructions and limitations
specified in the user's manual.
Connecting to Phone Line
Before connecting to the phone, make
sure to properly charge the battery for at
least 10 - 12 hours.
Plug one end of the telephone line cord
into the jack on the bottom of the base
unit. Plug the other end of this cord into
the wall jack.
Check for Dial Tone
After the battery is charged, pick up the handset and press
a dial tone.
BATTERY
1/0 1 12:00
/FLASH. You should hear
7
LOW
AM
Advertisement
Table of Contents
