Electrolux EWF1041R9WB User Manual page 22

22 www.electrolux.com
To Activate/Deactivate AutoDose
Softener ( )
Press AutoDose softener
toggle on and off, the relevant symbols
will show on display if enabled.
AutoDose configuration
mode
Enter the AutoDose configuration
mode before proceeding with any
program setting. The configuration
mode may cancel temporary
settings.
1. Press the On/Off button for a few
seconds to activate the appliance.
2. Wait about 10 seconds for appliance
internal check.
3. To enter in configuration mode, touch
and hold "Temp" and "Spin" touchpads
simultaneously for a few seconds until
appears on display.
4. Press Detergent touchpad to
select configure detergent dosage.
Touch the "Temp" touchpad repeatedly
to increase and "Spin" touchpad to
reduce. Minimum step is 1 ml (you can
press and hold touchpad to increase
the increment to 10ml/step).
5. Press
touchpad to
6. To save and exit configuration mode,
AutoDose low level indication
When the activated tank reaches a low level
of detergent,
continuously on the display.
It will stop blinking when the compartment is
refilled.
If tank is not refilled, once a program has
started, the indicator will stop blinking and
stay steadily lit. Once the program is fin-
ished, it will start blinking again.
If in both tanks detergent level is low, both
indicators blink, but only the set dosage for
detergent will be displayed.
Softener touchpad to select
configure softener dosage.
Touch the "Temp" touchpad repeatedly to
increase and "Spin" touchpad to reduce.
Minimum step is 1 ml (you can press and
hold touchpad to increase the increment
to 10ml/step).
press and hold "Temp" and "Spin"
touchpads combination again for 3
seconds or you can turn the knob to any
position.
Do not refill the AutoDose tanks unless
appliance indicates that one or both
tanks are empty.
indicator blinks slowly and
If the tanks are filled before the
appliance is powered on for the first
time, the AutoDose indicator will not
blink.
Refill the tanks with the same
detergent and fabric softener as
before. If changing either of the liquid
detergents, clean the tanks before
refilling (see section 8.5 for instructions
on how to clean the tanks).