Electrolux EWF1041R9WB User Manual page 15

Delay End (
Before you start the program, this option
makes it possible to define the end of the
washing program from minimum of 1 hour
to maximum of 20 hours.
If program duration is longer than
3 hours, minimum Delay End
option starts from 4 hours.
Press the Delay End touchpad to choose
the end time as you wish. The display
shows the number of hours and the
indicator beside the touchpad is on.
This option must be selected after
choosing the wash program, and
before pressing the "Start/Pause"
touchpad.
For example, if the program duration of
your selected program is 3.20 hours and
you define the "Delay End" time to 6
hours. This means your wash program
will finish in 6 hours. (See diagram)
"Delay End" Time : 6 hrs.
Countdown
2.40 hrs.
Pressed Start the
Start/Pause Program
After selecting Delay End time, press
Start/Pause touchpad to start the
program. Machine will then countdown
and update time on the display every
hours until it reaches the starting point of
the wash cycle.
If you wish to modify or cancel Delay End
option after starting the program, follow
the steps below:
set the washing machine to PAUSE by
–
pressing "Start/Pause" touchpad;
– deselect this option by pressing
"Delay End" touchpad, the display will
show delay time "
press the "Start/Pause" to start the
–
program.
) Touchpad
Working Cycle
3.20 hrs.
End of
Cycle
";
(
Select "
the sensors for the dirt and detergent
residue.
When using this option, the washing
machine will automatically check the dirt
level and detergent residue* on your
laundry. The machine will automatically
adjust the washing time and numbers of
rinses according to the load to make sure
that your clothes are really clean.
* Only for liquid detergent
The SensorWash technology consist of 2
different sensors for detection:
st
1) The 1 Turbidity sensor detects the
dirt level at the start of cycle and
automatically calculates the actual
time needed to remove the level of dirt
in the wash; from low dirt levels all the
way to the maximum dirt level.
The initial time displayed on the
control panel indicates the time
needed for the maximum dirt
level.
nd
2) The 2 Conductivity sensor will check
the amount of detergent residue after
the first rinse and the machine will
calculate the optimum number of
rinses (Maximum addition of 2 rinses)
needed to make sure that the
detergent residue is properly removed.
Please see details of detergent
usage at "Detergents Type and
Quantity of Detergent"
) Touchpad
" option to turn ON
15