Unpacking The Shipping Box - IBM DCS3700 Quick Start Manual

Unpacking the shipping box

Important: Do not remove the storage enclosure from the shipping box until the support rails are
installed in the rack cabinet. You must install the support rails in the rack cabinet before you
install the storage enclosure.
The disk drive modules (DDMs) that come with the storage enclosure are packaged in a smaller box
inside the shipping box. To unpack the shipping box, complete the following steps:
1. Remove the following items from the shipping box. Do not remove the DCS3700 storage subsystem or
DCS3700 storage subsystem with Performance Module Controllers from the shipping box at this time.
v Six full or empty boxes of DDMs
Note: The DDMs are packaged ten per box. The minimum order is 20 DDMs, so at least two of the
boxes are full. If you ordered less than the maximum number of 60 DDMs, one or more of
the boxes are empty.
v Box containing the mounting hardware kit
v Box containing storage enclosure handles
v Box containing the power cords and documentation
2. Check the items in the preceding list to ensure that you received all the necessary parts. See the
"Inventory list" on page 6 for the parts that are included with the storage enclosure.
5