Fujitsu General AK Series Operating Manual page 19

REVERSE CYCLE MODEL
Power Supply
Connect the Power Supply Plug to an electrical point.
● Connect securely, without looseness.
●
In the case of direct line connections, turn on the breaker.
MASTER CONTROL Switch
POSITION
HIGH POWER
(RED)
SUPER QUIET
(RED)
HIGH FAN
(OFF)
LOW FAN
SUPER QUIET
(BLUE)
HIGH POWER
(BLUE)
Cooling
To obtain maximum cooling effect in the hot summer select
position HIGH POWER (BLUE) on the MASTER CONTROL.
Maximum moisture removal, air circulation and dust removal
are effected at the same time.
Selection of SUPER QUIET (BLUE) reduces operating
noise.
Heating
To obtain maximum heating effect in severe winter select
position HIGH POWER (RED) on the MASTER CONTROL.
Maximum air circulation is obtained at the same time.
Selection of SUPER QUIET (RED) reduces heating effect and
operating noise. However you may feel a higher temperature
at the air outlet compared to the HIGH POWER (RED) position,
due to the reduced fan speed.
NOTE: After you start driving, it will take approximately
10 minutes for the air from this unit become warm.
This delay is normal.
FUNCTION
Fan (High Speed) and compressor operate - Rapid heating
effect at top capacity.
Fan (Low Speed) and compressor operate - Intermediate
heating effect and reduced operating noise.
High fan speed without heating/cooling - Room air is
circulated and cleaned.
The air conditioner is switched off.
Low fan speed without heating/cooling - Room air is
circulated and cleaned.
Fan (Low Speed) and compressor operate - Intermediate
cooling effect and reduced operating noise.
Fan (High Speed) and compressor operate - Rapid cooling
effect at top capacity.
Air Circulation
To maintain a comfortable room temperature, an important
factor is the circulation of air. Room air can be circulated
without cooling/heating by selecting either HIGH FAN or
LOW FAN position on the MASTER CONTROL.
Circulation of air without cooling/heating can be also effected
as follows:
1. When operating with the MASTER CONTROL switched
to HIGH POWER (RED) or SUPER QUIET (RED), turn the
thermostat fully clockwise.
2. When operating with the MASTER CONTROL switched
to HIGH POWER (BLUE) or SUPER QUIET (BLUE), turn
the thermostat fully counterclockwise.
MASTER CONTROL
5