HP workstation xw5000 Getting Started Manual page 42

troubleshooting
the system has no sound.
Make sure...
Software volume control is not turned down or
muted.
The speaker or optical drive volume control is
not turned down.
External speakers are plugged into the correct
audio port.
The optical drive audio cable is properly
connected.
Headphones or speakers connected to the line
out connector are not muting the internal
speaker.
The workstation is not in Standby mode.
3–8
table 3-5. audio problems
How
Open up the Speaker/Sound program and set
the volume. If the volume is muted, clear any
mute check boxes.
If your speakers or optical drive have volume
control knobs, turn the knob to increase the
volume.
Plug external speakers into the correct port on
the front- or rear-panel of the system. See the
"Connect the Components" section in this
guide for more information.
Connect the audio cable between the CD or
DVD-ROM drive and the system board. See
the hp workstation xw5000 and xw8000
Technical Reference Guides at
http://www.hp.com/go/workstationsupport
Turn on and use headphones or external
speakers, if connected, or disconnect
headphones or external speakers.
Press the power button to resume from Standby
mode.
getting started guide