Lubrication; Flushing Cooling Water Passage - Yamaha F200G Owner's Manual

TIP:
If fogging oil is not available, consult your
Yamaha dealer.
7. Turn off the water supply, and then re-
move the flushing attachment and wipe
off any excess water.
8. Install the top cowling and propeller.
9. Drain the cooling water completely out of
the outboard motor. Clean the exterior of
the outboard motor thoroughly.
EMU41071

Lubrication

1. Change the gear oil. For instructions, see
page 81. Check the gear oil for the pres-
ence of water that indicates a leaky seal.
Seal replacement should be performed
by an authorized Yamaha dealer prior to
use.
2. Lubricate all grease fittings. For further
details, see page 73.
TIP:
For long-term storage, fogging the engine
with fogging oil is recommended. Contact
your Yamaha dealer for information about
fogging oil and procedures for your outboard
motor.
EMU40962

Flushing cooling water passage

Perform this procedure right after operation
for the most thorough flushing.
ECM01530
NOTICE
Do not perform this procedure while the
engine is running. The water pump may be
damaged and severe damage from over-
heating can result.
1. Disconnect the garden hose connector
from the fitting on the bottom cowling.
ZMU07858
1. Fitting
2. Garden hose connector
2. Connect the garden hose to the garden
hose connector.
1. Garden hose
2. Garden hose adapter (commercially avail-
able)
3. Garden hose connector
3. With the engine off, turn on the water sup-
ply and let the water flush through the
cooling water passages for about 15 min-
utes.
Maintenance
2 1
ZMU07773
3 2 1
ZMU07774
67