SAFETY PRECAUTIONS REGULATION AND PRODUCT STANDARDS 1. During the adjustment of the table, do not put any part of the body into the gap of any moving parts. This table complies with the European regulation of medical devices (EU) 2017/745 and with the following 2.
The weight must be distributed Product dimensions along the table without concentrating on its ends to EL12 - Electrical Hi-Lo & Tilt Table maintain the correct stability. Length: 1950mm You should not sit on the head and foot sections. If Width: 640mm you do, there is a danger of tipping and table damage.
EL12 Electrical Hi-Lo & Tilt Table OPERATION Figure 1: Table in working position. Knob Square Tube Knob Red side down When installing the activity table do not relax Locked your hands before the activity table is fixed Locked / release...
Page 6
EL12C Electrical Child Tilt Table Fixing and adjusting the head/waist pad OPERATION Figure 1: Table in working position. Black knob Red side down ● Pushing the pole on the pad into the metal Locked Locked / release Figure 1 adapter adjust to the appropriate size then tighten the black knob.
Page 7
Adjusting the foot board plate Fix and adjust the activity table board Foot Bolt Knob Supporting rod Square Tube Knob Before adjusting make sure the table is in the non-tilting position. When installing the activity table, do not ● release the bolt then adjusting the relax your hands before the activity table is supporting rod...
Page 8
EL12D Electrical Tilt Table OPERATION Figure 1: Table in working position. Knob Square Tube Knob Red side down When installing the activity table do not relax Locked Locked / release Figure 1 your hands before the activity table is fixed to avoid accidental slippage and cause injury.
Page 9
EL12 Electrical Dynamic Tilt Table OPERATION Figure 1: Table in working position. Lowest Red side down Locked Locked / release Figure 1 Figure 2: Table in a in moving position. Highest Flat Release Release Figure 2 Connect the table to an electrical outlet using the power cord.
Page 10
● Step 2: Turn the black handle into the unlock position & the back section can then slide on the track. Single leg training ● Step 1: Remove the leg upholstery section Dynamic Position from the frame ● Step 2: Take the single leg pad from under the backrest &...
Page 11
Knob Square Tube Knob Black bolt When installing the activity table do not relax your hands before the activity table is fixed to avoid accidental slippage and cause Pull the black bolt to adjust the stroke, then lock injury. again ●...
Legend to symbols and information on the product - Check and clean the gas struts label. - Check and tighten screws (if necessary). - Model: Product identification. - Grease the parts with friction. - Model Num.: Product version. - Check the conditions of the electrical wiring and the socket.
TRANSPORTATION AND STORAGE CONDITION Transport condition The products can be transported by general means of transportation. They should be protected from the sun and rain, and should not be mixed with toxic, harmful and corrosive materials. Storage The packed electric multifunctional physiotherapy bed should be stored in a dry and well ventilated environment without corrosive gas.