SAFETY PRECAUTIONS REGULATION AND PRODUCT STANDARDS 1. During the adjustment of the table, do not put any part of the body into the gap of any moving parts. This table complies with the European regulation of medical devices (EU) 2017/745 and with the following 2.
This table generates, uses, and can radiate radio If the electrical supply cable is defective, frequency energy and, if not installed and used in disconnect the table immediately and inform your accordance with the instructions, may cause harmful dealer or a specialized technician. interference to other devices in the vicinity.
OPERATION Connect the bed to an electrical outlet using the power cord. Moving and adjusting the table The casters are controlled by a control rod on both Figure 4 ends of the table. ● Push the control rod down (it is recommended to In order to reduce the risk of injury caused by the use your feet to push) to activate the casters.
Legend to symbols and information on the product - Check and clean the gas struts label. - Check and tighten screws (if necessary). - Model: Product identification. - Grease the parts with friction. - Model Num.: Product version. - Check the conditions of the electrical wiring and the socket.
TRANSPORTATION AND STORAGE CONDITION Transport condition The products can be transported by general means of transportation. They should be protected from the sun and rain, and should not be mixed with toxic, harmful and corrosive materials. Storage The packed electric multifunctional physiotherapy bed should be stored in a dry and well ventilated environment without corrosive gas.