Configuring An Integrated Striping Array - HP xw4200 User Manual

Press any key during POST to view POST messages.
2.
During the reboot, press CTRL-C to enter the LSI Logic Configuration Utility when the following is
3.
displayed on the monitor.
Press Ctrl-C to start LSI Logic Configuration Utility...
Select the Adapter that you want to configure an array on.
4.
Select <RAID Properties>.
5.
Use the arrow key (up or down) to select the primary drive you want to include in the array and
6.
press Space.
If you are migrating a single drive (OS or data) to an array, press F3; otherwise, press Delete.
7.
Use the arrow key (up or down) to select the next drive you want to include in the array and press
8.
Space.
Repeat step 8 to include any additional drives to the array. An array can have 2 to 6 drives.
9.
Press Esc.
10.
Use the arrow key (up or down) to select <Save changes then exit this menu> then press
11.
Enter.
Press Esc.
12.
Use the arrow key (up or down) to select <Exit the Configuration Utility> then press Enter.
13.

Configuring an Integrated Striping array

1. Restart your workstation.
2. Press any key during POST to view POST messages.
3. During the reboot, press CTRL-C to enter the LSI Logic Configuration Utility when the following is
displayed on the monitor:
Press Ctrl-C to start LSI Logic Configuration Utility...
4. Select the Adapter that you want to configure an array on.
5. Select <RAID Properties>.
6. Use the arrow key (up or down) to select the first HDD you want to include in the array.
7. Press Space to toggle Array Disk? = [Yes].
8. Repeat steps 6 and 7 so the array can include 2 to 6 HDDs.
9. Press Esc.
10. Use the arrow key (up or down) to select <Save changes then exit this menu> then press
Enter.
11. Press Esc.
12. Use the arrow key (up or down) to select <Exit the Configuration Utility> then press Enter.
Migrating to a Integrated Mirroring Enhanced array using HP Recovery
Media
Complete steps in section labeled
1.
integrated RAID.
Steps common to all methods for enabling LSI