Configuring The Integrated A-Class Web Console - HP Rp2430 - Server - 650 MHz User Manual

A-Class Server Installation
A-Class Server Power Up and Boot Procedures

Configuring the integrated A-Class Web Console

The integrated A-Class Web Console is preconfigured with IP address 192.0.0.192.
CAUTION
Power-off any other devices with the same IP address before proceeding with integrated
A-Class Web Console configuration. Each A-Class server must be configured to the
integrated A-Class Web Console with an individual IP address.
Failure to follow this precaution will result in unexpected behavior of the Local Area
Network (LAN).
Configuring The Web Browser Host
NOTE The A-Class server and the Web Browser Host must be on the same subnet.
Enter the following commands into either a DOS window or UNIX widow on the host
where the browser used to configure the integrated A-Class Web Console resides:
Step 1. Route add 192.0.0.192 <host IP address>.
Step 2. ping 192.0.0.192.
Step 3. arp -s 192.0.0.192 <MAC_ address of integrated A-Class Web Console>.
Step 4. Repeat Step 2.
NOTE Using the arp command requires superuser capability.
The MAC address of the integrated A-Class Web Console appears on the rear label of the
server in a field entitled, "MAC Address." The MAC address must be entered in the
correct format. For example:
PCs: 00-60-b0-22-3e-ae
CAUTION DO NOT enter the "LAN Station Address" value (located on the rear label) in place of the
"MAC Address" value (also located on the rear label). If the wrong number is erroneously
entered, use the arp -d command to correct the entry.
Failure to follow this precaution will cause the integrated A-Class Web Console to
malfunction.
50
If ping is unsuccessful, proceed to step 3.
If ping is successful, proceed to Configure the Web Browser.
Unix workstations: 00:60:b0:22:3e:ae
Chapter 2