Turning Off The Workstation - HP xw4100 Getting Started Manual

NOTE: If your workstation does not support Hyper-Threading
Technology, the Hyper-Threading menu item will not be available on
Computer Setup
the
NOTE: To enable hyper–threading, Linux systems require the latest
system BIOS and an SMP kernel (for systems installed with a single
processor). For additional information concerning the setup of
Linux–preinstalled or Linux–enabled workstations, refer to the
HP User Manual for Linux, located at
www.hp.com/support/linux_user_manual.
For more information about the Hyper-Threading Technology, you can
visit the Intel® website at www.intel.com.

Turning off the Workstation

To properly turn off the workstation, first shut down the operating
system software.
CAUTION: Manually forcing the workstation off can cause loss of
data.
To manually turn off power to the workstation, press and hold the power
button for four seconds. However, manually turning off the power
bypasses the standby state and can result in loss of data.
To reconfigure the power button to work in On/Off mode, run Computer
Setup (F10). Refer to the Service and Technical Reference Guide web
link located on the Documentation Library CD
(www.hp.com/support/workstation_manuals) for more information
about using the Computer Setup (F10) utility.
Getting Started Guide
menu.
www.hp.com
Software Setup
2–9