HP Visualize j6000 Supplementary Manual page 68

Troubleshooting
Identifying LCD-Indicated Conditions
Table 3-1. Chassis Codes for J6000 Workstations
Ostat Code FRU
FLT CBFF SYS BD
INI CC0n SYS BD
INI CC1n SYS BD
INI CC2n SYS BD
INI CC3n SYS BD
INI CC4n SYS BD
TST D000 SYS BD
WRN D004 SYS BD
INI D005 SYS BD
INI D006 SYS BD
WRN D007 SYS BD
FLT D01n SYS/IO
WRN D02n SYS/IO
68
Message
multiple HPMCs
CPU n OS rendezvs
CPU n early rend
CPU n rendezvous
CPU n cache rend
CPU n mem rendez
micro controller
micro not resp
set dom1 fan spd
set dom2 fan spd
bad microctl cmd
fan n : failure!
fan n : too slow!
Description
A High-Priority Machine Check occurred
while processing another HPMC.
Slave CPU n entering the final
rendezvous, waiting for the operating
system to awaken it.
Slave CPU n entering the early
rendezvous, waiting for the monarch CPU
to initialize scratch RAM and other
system state.
Slave CPU n entering rendezvous. Slave
CPUs enter this rendezvous numerous
times during boot.
Slave CPU n entering cached rendezvous,
waiting for the monarch CPU to configure
the system bus.
Slave CPU n entering memory
rendezvous, waiting for the monarch CPU
to select a boot device.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware is initializing communications
with the system controller.
Firmware is initializing communications
with the system controller.
Firmware detected a communications
error with the system controller.
Firmware detected system fan n stopped.
Firmware detected system fan n is
running too slowly.
Chapter 3