Displaying And Setting The Monitor Type; The Monitor Command - HP Visualize J5000 Owner's Manual

NOTE

Displaying and Setting the Monitor Type

Your system ships from the factory preset to use a monitor with a specific
resolution and frequency. If you replace your computer's monitor with a
different type of monitor, you may have to reconfigure your computer to
support the new monitor.

The Monitor Command

The monitor command lets you change your computer's graphics
configuration. This command is available in the Configuration Menu of
the boot console interface.
The monitor command lets you change your computer's graphics
configuration before you replace your monitor. For information about
changing the configuration after you replace your monitor, refer to
"Changing Your Monitor Type" on page 57.
To display the current graphics and console information, type the
following set of commands and press
Main Menu: Enter command> co
Configuration Menu: Enter command> mo
The correct usage for setting the graphics configuration is:
monitor graphics_path
where valid graphics_path parameters are:
Graphics card installed in slot 4
graphics(4)
Graphics card installed in slot 7
graphics(7)
and type is the numerical monitor type.
Chapter 8
The Boot Console Interface
Displaying and Setting the Monitor Type
at each prompt:
Enter
type
147