HP Visualize B1000 Supplementary Manual page 40

Parts Removal and Replacement
Removing and Replacing the System Board
Figure 2-35. Removing the System Board
T-15 Torx Screws
2. Remove the two T-15 Torx screws that secure the system board tray to the rear wall of
the workstation.
3. Grasp the system-board tray handle and slide the system board tray toward the front of
the workstation to unseat the keyhole standoffs on the floor of the chassis, underneath
the board. Using the handle, lift the system board tray out of the workstation and place
it on the conductive sheeting.
NOTE Do not remove the system board from the tray.
40
System board
tray handle
Chapter 2