Floppy Disk Drive; Removing The Floppy Disk Drive - HP Visualize B1000 Supplementary Manual

Parts Removal and Replacement

Floppy Disk Drive

Floppy Disk Drive
This section describes how to remove and replace the Floppy Disk Drive.
NOTE Prior to removing the Floppy Disk Drive, the Left Side Panel needs to be
removed. See the appropriate section(s) for the steps to remove and replace
this component.

Removing the Floppy Disk Drive

1. Remove the two T-15 Torx screws that secure the floppy drive tray to the front of the
chassis.
Figure 2-26. Floppy Disk Drive Removal: External
T-15 Torx Screw
2. Facing the opened side of the workstation, remove the T-15 Torx screw that secures the
back cover of the floppy disk drive bay, and then remove the back cover. Reach into the
back of the floppy disk drive bay and disconnect the two cables: the floppy disk drive
power cable and the ribbon cable. Disconnect these same cables from the system board
and set them aside.
30
T-15 Torx Screw
Chapter 2