Configuring An Ide Device After Installation - HP Vectra VL6 6 User Manual

Jumper Settings
2 How to Install Accessories In Your PC
Installing Mass Storage Devices
Up to four IDE devices can be connected to the system board using
these data cables. (Refer to the storage device's manual to check
whether you need to set jumpers, or if there are any special installation
procedures.)
Examples of multiple IDE drive combinations
Configuration
1 Hard disk drive 1. Bootable hard disk drive:
2 Hard disk drives 1. Bootable hard disk drive:
2. Second hard disk drive:
1 Hard disk drive 1. Bootable hard disk drive:
1 CD-ROM drive 2. CD-ROM drive:
2 Hard disk drives 1. Bootable hard disk drive:
1 CD-ROM drive 2. Second hard disk drive:
3. CD-ROM drive:
1 Hard disk drive 1. Bootable hard disk drive:
1 CD-ROM drive 2. CD-ROM drive:
1 Zip drive 3. Zip drive:
2 Hard disk drives 1. Bootable hard disk drive:
1 CD-ROM drive 2. Second hard disk drive:
1 Zip drive 3. CD-ROM drive:
4. Zip drive:
Refer to the IDE drive's manual to see if you must set jumpers. The drive
jumper should be set to "cable select".

Configuring an IDE Device After Installation

After installing a second IDE drive, or after installing any flexible disk
drive, you will need to verify that your PC has correctly identified the
new configuration, by viewing the HP Summary Screen. Refer to page
44. If the configuration is not correct, run the Setup program to
configure the device. Refer to "HP Setup Program" on page 66.
28 English
Connections to data cables
Master connector, HDD Cable
Master connector, HDD Cable
Slave connector, HDD Cable
Master connector, HDD Cable
Master connector, CD-ROM Cable
Master connector, HDD Cable
Slave connector, HDD Cable
Master Connector, CD-ROM Cable
Master connector, HDD Cable
Master connector, CD-ROM Cable
Slave connector, CD-ROM Cable
Master connector, HDD Cable
Slave connector, HDD Cable
Master connector, CD-ROM Cable
Slave connector, CD-ROM Cable