Configuring An Ide Device After Installation - HP Vectra VLi8 Supplementary Manual

2 How to Install and Replace Components In Your Desktop PC
Upgrading and Installing Mass Storage Devices

Configuring an IDE Device After Installation

After installing any device, you will need to verify that your PC has
correctly identified the new configuration, by viewing the HP Summary
Screen. If the configuration is not correct, run the Setup program to
configure the device. To enter the Setup program, press during
F2
startup.
IDE drives are automatically detected by the Setup program. However,
a newly installed device may require that you install an appropriate
device driver. Refer to your operating system documentation for
details. You can obtain the latest drivers from HP's Web site at:
.
www.hp.com/go/vectrasupport
63